Here are the different ways to use Glue Dots® Adhesives.
The spider web was made with Glue Dots® Adhesives Continuous Lines and covered with Martha Stewart black flock. Lay down each line of adhesive, rub it with your finger then remove the plastic. Rubbing the adhesive down before removing the plastic assures that the Glue Dots® Adhesive is evenly adhered to the canvas. Then take the black flocking and spread it across the adhesive, lightly pressing it into the Continuous Lines. Tap off all excess. Because your Glue Dots® Adhesives are not wet you can use a soft brush to remove any flocking that is on the canvas.
The foil accents around the edges were made with Craft Glue Dots® by stretching them onto the canvas, rubbing the foil on top of it. If you wait a day the strength the adhesive will cause it to reshape itself giving the foiled accent a distressed look. You can go back over it and rub a little more foil onto the adhesive after it “distresses.”
Used Craft Glue Dots® and stretch them across the witches hat and broom. Then wrap the edges of the adhesive underneath so it will leave a smooth edge. Our Craft Lounge Platinum Sparkly Fluff was then added by pressing it into the adhesive. By using Craft Glue Dots® you can get a much thicker look and feel for the fluff.
Pop Up Glue Dots® are a favorite Glue Dots® for creating 3D Dimension! Instead of being “sticky” on the top and bottom, Pop Up Glue Dots® are all “sticky” on all sides since they are thicker. You can also stack them as you wish to create the right height as seen here with the lamp post and spider.
Project and Photo Credit- Debbie Lewis- http://debbysdares.blogspot.com
